Grid Power PSF90

PSF90 SERIES WATERPROOF CONNECTORS

Flat wiping contact system
Minimal contact resistance at high current, wiping action cleans
contact surface during connection/disconnection

Mechanical keyed housings
Prevents accidental mating of components operating at different
voltage levels

Water proof
Connector pair inserted to waterproofing level IP67

Ergonomic design
Is “user friendly” during connection and disconnection
of the system

Lock catch
Self-locking function with secondary reinforcement lock

Docking
Board to Line and Line to Line

Either power cables and signal wires must be inserted thru Rear Cover (8) and “Terminal Wire Ring” (7)
Strip cables and wires-crimp either Power Contact (5) and Signal Contacts (12-6)
Insert Power Contacts according positive and negative polarity indicated on Connector Housing Male (2)
or Female (9)
Insert Male Signal Contacts into Holder (11) positioned into Female Housing (9) and female Signal Contacts
into Holder (1) positioned into Male Housing (2) then push Terminal Wire Ring (7) and lock Rear Cover (8)

Either Rear Cover (8) and “Terminal Wire Ring” (7) must be pulled back along cables and wires
To remove Power Contacts simply with a small screw driver pushing down retaining springs and pull cables
To remove Signal Contacts it is necessary to extract Holders (1 or 11) from housing male or female using special
tools (see “Tooling” section). To insert tool from front for female housing and rear for male one then to pull signal
wires or using a little pincer. In case of “Repair” it is necessary to replace Holder and contacts

Crimping tool for Signal Contacts: Cat. Nr. W2D

To remove Holder (11) from female Housing (9)
use: Cat. Nr. 28×10002

To remove Holder (1) from male Housing (2)
use: Cat. Nr. 28×10001